engine miss
Thread Starter
|
New User
Joined: May 2011
Posts: 2
Likes: 0
engine miss
just recently on 02 expedition with 4.6 liter i had engine light for cylinder 1 and 2 miss and i also was losing coolant so thought it was head gasket but as i started tearing it down i noticed intake manifold bolts 3 of em were loose
the question is should i just replace intake gaskets and put back together? or should i proceed with head gasket and is this common for bolts to come loose?
the question is should i just replace intake gaskets and put back together? or should i proceed with head gasket and is this common for bolts to come loose?
Thread Starter
|
New User
Joined: May 2011
Posts: 2
Likes: 0
engine miss
compression checked out good i put engine back together and runs good no engine light the thing is i had the battery un hooked for a week and at idle its a little unstable but not bad do u think its trying to relearn itself because i checked for vacumm leaks and if it was a big problem the ecm should set a code and if it is a relearn issue how long will take to stabilize and at idle with ac off it shows 30% load in park is that normal
Thread
Thread Starter
Forum
Replies
Last Post
73FOMO
Small Block V8 (221, 260, 289, 5.0/302, 5.8/351W)
1
Feb 2, 2014 11:20 PM
pushinoleblue
Ford Inline Six, 200, 250, 4.9L / 300
20
Nov 10, 2009 10:22 PM
FalconStng
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
6
Jan 28, 2006 12:25 PM
