Custom Made Side Pipes!!
Thread Starter
|
Mountain Pass
Joined: May 2008
Posts: 241
Likes: 0
From: Oregon
Custom Made Side Pipes!!
Well I finaly did it. Finaly made her some custom made side pipes! 
I used Flowtech Red Hot glass packs on both sides with 2.25" exhaust pipe and out turns on the end. She looks mean with them mounted up there. It only took about 26 hours of measuring, welding, grinding, and cutting to get it done. I think I may have gained a little touch of power with those too? Seeing as how the exhaust gasses dont have to go through a maze in a muffler, it just goes stright out.
I used Flowtech Red Hot glass packs on both sides with 2.25" exhaust pipe and out turns on the end. She looks mean with them mounted up there. It only took about 26 hours of measuring, welding, grinding, and cutting to get it done. I think I may have gained a little touch of power with those too? Seeing as how the exhaust gasses dont have to go through a maze in a muffler, it just goes stright out.
Thread Starter
|
Mountain Pass
Joined: May 2008
Posts: 241
Likes: 0
From: Oregon
Thanks, she does sound good. And I get to have the satisfaction of knowing that my friend and I made them rather then buying a kit. Although I bet my neighbors hate them though ha ha. It sounds realllly gooood when the secondarys open up. But sadly not as much as a chick magnet as I was hoping for ha ha. I did save a bit of money doing it this way though.
And how meny trucks, much less other vehicles, do you see with side pipes now a days?
And how meny trucks, much less other vehicles, do you see with side pipes now a days?
Thread
Thread Starter
Forum
Replies
Last Post
Midnite1987
1987 - 1996 F150 & Larger F-Series Trucks
266
Nov 1, 2014 10:35 AM
