dana 60 torque ???
Thread Starter
|
Senior User
Joined: Nov 2010
Posts: 373
Likes: 0
From: Chesapeake Va.
dana 60 torque ???
I've searched here and seen it get asked here but never really answered
Soooo, what are the CORRECT torque specs for the rear axle 2 9/16 inner and outer nuts against the wheel bearings and the axle shaft 5/8 bolts?
Soooo, what are the CORRECT torque specs for the rear axle 2 9/16 inner and outer nuts against the wheel bearings and the axle shaft 5/8 bolts?
Senior User
Joined: Nov 2007
Posts: 340
Likes: 4
From: Near Madison, WI
The axle shaft bolts I wanna say get 60 ft lbs? That or tight plus a quarter. The inner spindle nuts don't really get torqued. Tighten the inner nut until there is significant drag on the hub when you're spinning it. Then back it off half a turn and re-tighten while spinning the hub until you get slight drag. With new bearings it's a good idea to pre-load them a little more. The locking washer deal goes in next, followed by the other nut. Snug it up good and bend the tabs on the lock washer over the nut.
-Jared
-Jared
Thread
Thread Starter
Forum
Replies
Last Post
AzSuperDuty
1999 - 2016 Super Duty
4
Jun 28, 2016 01:58 PM
newfordguy88
Clutch, Transmission, Differential, Axle & Transfer Case
4
Nov 14, 2005 08:42 AM
