Intake help

Reply Subscribe

Thread Tools

Search this Thread

Dec 18, 2010 | 10:13 PM

wa150

Thread Starter

New User

Joined: May 2010

Posts: 21

Likes: 0

Intake help

I purchased a new 400m and had some mods done which included decking the motor. Can I pull my intake manifold off my stock 400m and put it on the new block without any problems or will I need to do something to the intake?

Dec 21, 2010 | 02:26 PM

beartracks

Lead Driver

Joined: Nov 2000

Posts: 6,648

Likes: 352

From: Albuquerque

You can but I would spring for an Edlebrock Performer intake. Not that expensive given the labor involved. You would need a 4v carb though. Small size if the engine is mostly stock.

Dec 21, 2010 | 09:38 PM

wa150

Thread Starter

New User

Joined: May 2010

Posts: 21

Likes: 0

Sorry. The 400m is mostly stock. The intake is already an Edelbrock Performer which was originally told in the message before I edited it. Also, I took a 600 cfm Edelbrock off and am expecting my 650 thunder series any day now. Other than that it was stock. I might even ask what is the best way to clean an old aluminum intake. It has been sitting in the elements ( rain cold sun more rain and cold some sun I live in Wa. state ). It has some white stuff all over it and who knows what grew inside over the last 15 years of exposure.