Driver Seat presets button

Reply Subscribe

Thread Tools

Search this Thread

Dec 3, 2010 | 09:35 AM

tjhanes

Thread Starter

New User

Joined: Nov 2010

Posts: 3

Likes: 0

Driver Seat presets button

I went to push in one of the driver seat preset buttons (on the side of the seat and it says "SET" "1" or "2"), and the entire unit came unfastened and pushed/recessed into the plastic housing of the chair. It is visible, but my fingers can't get a grip to pull it back. Is there a quick way to pop off the side plastic of the front chair? or will the entire chair have to come off/out to get that secured back into place? Any thoughts?

Thanx. Tj

Dec 3, 2010 | 10:14 AM

fastcarsspeed

5th Wheeling

Joined: Dec 2007

Posts: 25

Likes: 0

I believe that whole plastic shroud comes off in pieces. Like the front of the chair and rear of the chair comes off and then I bet you will see some screws on the sides.

Dec 3, 2010 | 02:23 PM

Blacknav

Junior User

Joined: Mar 2008

Posts: 57

Likes: 0

The plastic panel on the side of the seat is held in by clips (no screws) . Just be careful when prying cause the plastic tabs can break easily

Dec 5, 2010 | 06:13 AM

tjhanes

Thread Starter

New User

Joined: Nov 2010

Posts: 3

Likes: 0

Quote:

Originally Posted by Blacknav

The plastic panel on the side of the seat is held in by clips (no screws) . Just be careful when prying cause the plastic tabs can break easily

Perfect explanation, thanx!! That gave me a little confidence in going in there. I actually had to take off the front plastic panel before I could take off that side panel. And there was one screw holding in one corner of that second/side panel.

Nonetheless, thanx for the help. I got it locked back in place and I'm in business again!

Tj.