engine removal newbie
Thread Starter
|
Freshman User
Joined: Jun 2010
Posts: 45
Likes: 0
engine removal newbie
hey all,
newbie back, been working in my beauty in between jobs. i'm ready to pull the motor and tranny. my question is , the drive shat universals do not have clamps to remove, and there is a device coupled to the tranny and the drive shaft that is bolted down on the crossmember, does the drive shaft yoke slide out of that thing, or should i take out the 4 bolts that attach it to the tranny?i am doing this alone and would rather ask than have a battle on my hands.
check pics in albums...
newbie back, been working in my beauty in between jobs. i'm ready to pull the motor and tranny. my question is , the drive shat universals do not have clamps to remove, and there is a device coupled to the tranny and the drive shaft that is bolted down on the crossmember, does the drive shaft yoke slide out of that thing, or should i take out the 4 bolts that attach it to the tranny?i am doing this alone and would rather ask than have a battle on my hands.
check pics in albums...
Last edited by jimmimac; Nov 11, 2010 at 05:51 AM. Reason: added comment on album
Thread
Thread Starter
Forum
Replies
Last Post
roshan
1948 - 1956 F1, F100 & Larger F-Series Trucks
15
Aug 12, 2013 03:43 PM
KraZeDav
Clutch, Transmission, Differential, Axle & Transfer Case
18
Oct 22, 2011 06:34 PM
bcmchong
1994.5 - 1997 7.3L Power Stroke Diesel
3
Jul 19, 2004 12:47 AM
