87 to 90 8.8 yoke swap?
#1
87 to 90 8.8 yoke swap?
I have a 1990 Bronco, there was a ton of play in the rearend, so I picked up a really nice 8.8 for $100, but it has a different yoke than my 8.8, it's the strap style instead of the flange style.
Is it as simple as bolting the yoke from the 90s on the other rearend? I think the new 8.8 is an 87'.
If I were swapping the same, even with the crush sleeve I'd just mark the nut to make sure I got preload correct.. however, I'm not sure about swapping the different style yokes.
I prefer the flange to the strap, so I'd rather change the yoke on the 8.8 than on my driveshaft.
Is it as simple as bolting the yoke from the 90s on the other rearend? I think the new 8.8 is an 87'.
If I were swapping the same, even with the crush sleeve I'd just mark the nut to make sure I got preload correct.. however, I'm not sure about swapping the different style yokes.
I prefer the flange to the strap, so I'd rather change the yoke on the 8.8 than on my driveshaft.
#2
Thread
Thread Starter
Forum
Replies
Last Post
monckywrench
Clutch, Transmission, Differential, Axle & Transfer Case
2
10-22-2006 06:50 AM