Inconsistent boost readings
#1
Inconsistent boost readings
I recently purchased scanguage 2 and have installed. Also did some exhaust work at the time. When accelerating under hard throttle I have noticed the scanguage reads up to 22psi boost, then instantly switches to -13 psi. Factory guage continues to read over 20 psi. I don't trust factory guages for much, but I find it difficult to believe that I am going from 22+ PSI to -13 psi in 2 seconds. Any one else ever seen this. There may or may not be a very small exhaust leak on drivers side manifold to up-pipe connection. Cannot see or feel anything when running, and bolts are tight.
Thread
Thread Starter
Forum
Replies
Last Post
derek0525
1999 - 2003 7.3L Power Stroke Diesel
13
01-19-2016 03:57 PM
UP_There
1999 - 2003 7.3L Power Stroke Diesel
10
12-04-2008 06:10 PM