You are currently viewing our forums as a guest, which gives you limited access to view most discussions and access our other features. By joining our community you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is fast, simple and absolutely free so please, join the Ford-Trucks Forums community today!
I'm looking for a replacement diff for my "other" truck that is fairly strong (9" or 8.8), 4.10 ratio and correct width (@60") with 5 lug pattern. Explorer is close but the ratio seems hard to find or very expensive.
I had a 4.10 Trak-Loc in my '89 EB, but they're a 7.5" and definitely not strong. The Trak-Loc version tends to oval one of the spider shaft bores in the ring carrier and you get a rattle. And mine had significant decel pinion bearing noise at around 300k miles.
Is the 8.8" from a 4.0l 2WD Aero available in 4.10 ?
I don't think so. The only 4.10 ratios I see are for the 7.5" diffs in Aeros, according to this list I got from somewhere years back. The comments are not mine:
Gee, did some Aerostars actually come with aluminum rear axle housings? I know the front axle on my AWD is a Dana 28, and I think it is aluminum. But I don't think I've ever seen one with an aluminum rear axle housing.
Previously I had looked for LSD 8.8" axles with 3.73 ratio, and could not find any. If your list is all-inclusive, that explains why. I was hoping to replace the 7.5" rear axle with an 8.8" of the same ratio, and with a LSD.
Yes, I'm an engineer with a welder, and my Exp front brake adaption is still working flawlessly.
The big-tube 8.8 w/discs is way heavier than the Aero 7.5.
From lifting just one end, I expect the total to come in at around 250lbs.
Surprise, this '97 example needs to be widened, not narrowed, to match the Aero track.
If and when, the project will go into the Built-to-tow thread.
I'm sure you'll remember Explorer Brakes On An Aerostar.
Fronts currently overshadow the weaker (10") rear drums.
The inbound rear discs will then become too strong with the stock MC and need the Exp MC to balance correctly.
And one Exp MC has bias adjust.
This forum is owned and operated by Internet Brands, Inc., a Delaware corporation. It is not authorized or endorsed by the Ford Motor Company and is not affiliated with the Ford Motor Company or its related companies in any way. FordŽ is a registered trademark of the Ford Motor Company.