Tow Haul on in Park turns off in gear - Not Flashing
#1
Tow Haul on in Park turns off in gear - Not Flashing
Hey all -
I have searched and searched today on what my truck is doing but for the life of me can't find an answer. This is my 03 F250 6.0 truck.
I went to move a horse today and hooked up the trailer, warmed the truck, added horses and off I went.
When I started the truck I had pushed the Tow/Haul button and it was on and not flashing. As I got up the highway a few miles I noticed that the Tow/Haul light was off so I pressed the button again and nothing, no light would go on.
I got the horse where is needed to go and took a look at the truck, the scanguage 2 was showing one code P2285, that is an ICP code and I knew it was there and was expected, was actually going to fix that tomorrow.
So now I can start the truck and idling in park I can press the Tow/Haul light and it will go on, as soon as the truck is put in gear it goes out and will not come back on.
I am going to go out and look at fuses, are there maybe codes that the scanguage can not see ?
I can not find any other instances of this happening and I have been searching for a couple of hours.
Im Stumped ... anyone ?
Thanks
T
I have searched and searched today on what my truck is doing but for the life of me can't find an answer. This is my 03 F250 6.0 truck.
I went to move a horse today and hooked up the trailer, warmed the truck, added horses and off I went.
When I started the truck I had pushed the Tow/Haul button and it was on and not flashing. As I got up the highway a few miles I noticed that the Tow/Haul light was off so I pressed the button again and nothing, no light would go on.
I got the horse where is needed to go and took a look at the truck, the scanguage 2 was showing one code P2285, that is an ICP code and I knew it was there and was expected, was actually going to fix that tomorrow.
So now I can start the truck and idling in park I can press the Tow/Haul light and it will go on, as soon as the truck is put in gear it goes out and will not come back on.
I am going to go out and look at fuses, are there maybe codes that the scanguage can not see ?
I can not find any other instances of this happening and I have been searching for a couple of hours.
Im Stumped ... anyone ?
Thanks
T
#2
Thread
Thread Starter
Forum
Replies
Last Post