Repairing stripped head threads
#1
Repairing stripped head threads
I goofed this morning and stripped a head thread on our 223….Dang, I've had quite a bit of bad luck on the engine part of this project.
I'm reaching out to get advice on repairing this. For background on this engine, read my last post https://www.ford-trucks.com/forums/1...-question.html .
I think I may have crossed threaded the bolt with the hole threads, and when torquing the bolt, the threads in the block failed.
I am wondering if it might be best to drill and tap this one hole for the 1/2" thread size, though the others will be 7/16".
Thanks
I'm reaching out to get advice on repairing this. For background on this engine, read my last post https://www.ford-trucks.com/forums/1...-question.html .
I think I may have crossed threaded the bolt with the hole threads, and when torquing the bolt, the threads in the block failed.
I am wondering if it might be best to drill and tap this one hole for the 1/2" thread size, though the others will be 7/16".
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
nookiemonster55
1999 - 2003 7.3L Power Stroke Diesel
3
12-10-2014 08:59 PM
302grabber
FE & FT Big Block V8 (332, 352, 360, 390, 406, 410, 427, 428)
6
01-03-2010 07:55 AM
low54
Y-Block V8 (239, 272, 292, 312, 317, 341, 368)
20
05-10-2009 09:07 PM