Torque converter, made a mistake!
#1
Torque converter, made a mistake!
Guys,
I have a 2001 excusion 7.3 diesel with a 4r100 trans. I followed the threads to do a fluid change and I did everything as instructed except - the TC drain plug. Instead of torquing the plug to 18 ft lbs, I drove the plug in too far, I think.
Now, I have a clicking, clanking noise at the TC when I put it in reverse. I also notice the noise in drive when it shifts in some cases. I did back off the plug and it did stop until the next day when the fluid was cold.
What did I do to this TC.? I will back off the plug again and test it. But any insight would be appreciated.
Great site by the way.
I have a 2001 excusion 7.3 diesel with a 4r100 trans. I followed the threads to do a fluid change and I did everything as instructed except - the TC drain plug. Instead of torquing the plug to 18 ft lbs, I drove the plug in too far, I think.
Now, I have a clicking, clanking noise at the TC when I put it in reverse. I also notice the noise in drive when it shifts in some cases. I did back off the plug and it did stop until the next day when the fluid was cold.
What did I do to this TC.? I will back off the plug again and test it. But any insight would be appreciated.
Great site by the way.
Thread
Thread Starter
Forum
Replies
Last Post
redneckboy
1999 - 2003 7.3L Power Stroke Diesel
8
02-19-2007 10:17 PM
KennyG228
Clutch, Transmission, Differential, Axle & Transfer Case
1
02-16-2004 11:06 PM