Phantom Aluminum Intake
#1
Phantom Aluminum Intake
I purchased my 76 F100 and in the cab was an Eldebrock Intake for a 6 cyl. I have searched all on the internet for this intake to find the specs on it and have come up with nothing so here I am hoping someone can help
On the top of the intake it has Edelbrock FORD 300 6C 1V
Underneath the intake it has 5557
On the top of the intake it has Edelbrock FORD 300 6C 1V
Underneath the intake it has 5557
#2
#3
I have tried using their website but as you said it wasn't even listed but no I have not called them to ask. I was hoping someones here may have an idea if its worth swapping out for stock. I am working on bodywork now before I tackle the engine but figured I would put it out there
#4
#5
If you put that intake on eBay you'll probably get enough to buy a new Offy 4v intake and a new 4v carb. It's a rare piece and pretty sought after. Supposed to improve torque over the stock intake at low rpm, but as you would expect with a one barrel carb it is limited at higher rpm.
If you're looking for low end and not planning on turning revs it's a sweet piece. But you could parlay it into a few new performance parts.
If you're looking for low end and not planning on turning revs it's a sweet piece. But you could parlay it into a few new performance parts.
#6
If you put that intake on eBay you'll probably get enough to buy a new Offy 4v intake and a new 4v carb. It's a rare piece and pretty sought after. Supposed to improve torque over the stock intake at low rpm, but as you would expect with a one barrel carb it is limited at higher rpm.
If you're looking for low end and not planning on turning revs it's a sweet piece. But you could parlay it into a few new performance parts.
If you're looking for low end and not planning on turning revs it's a sweet piece. But you could parlay it into a few new performance parts.
The biggest purpose will be for pulling my boat and although the weight is right at the limits i am more worried about low end torque than speed at this point.
#7
Ok I called Edelbrock today....although the tech guy was quite short and "unfriendly" he did tell me that I should get 10-15 ft lbs of torque and 8-20 hp by installing this intake. He said its about 30 years old so I guess the question now is do I install now or wait to decide what direction I am going.
Trending Topics
#9
#10
#11
Put it on eBay if you want to maximize the price. Just guessing based on the rarity I'd say you could get $400-500, easy.
#12
You think so??? Well it costs money to sell on Ebay so maybe I will just keep it in here to sell it. I would rather sell it to someone that contributes to this forum than not. Granted its not a auction like ebay but I guess I can just list a price and go from there maybe....what you think?
#14
#15
I suggest checking out Fordsix. com . There is a lot of good info there and there are always guys looking for an Edelbrock intake.
If you are going to try and sell it on a forum expect to get around $350. You'll get more by selling it on Ebay. A lot more people will see it. And a bidding war will bring more $$.
If you are going to try and sell it on a forum expect to get around $350. You'll get more by selling it on Ebay. A lot more people will see it. And a bidding war will bring more $$.