Just trying to figure out if this is the route i wanted to take. i've done a search and read up on the threads regarding this subject, i probably will try to rebuild the motors on the windows for my '89 4 door f350 4x4. but just in case that doesn't work out, i'm wondering if i can take a manual window regulator plus the interior panel off of any f series truck or does it have to be from a 4 door f350? i understand that some parts of the panels might not match up with the dash if they're from a different generation truck.

thanks!

 

all you really have to do is drill a hole for the hand crank and leave the switches there till you find manual door panels.

as for the regulators, remove the power ones and replace with manual ones.

 

I think the easiest way would be to find manual doors at the boneyard.

 

that sounds like a good plan

if i went this route, does the donor vehicle have to be a 4 door f350? or are the front doors all the same? i have an 89

 

Not trying to hijack, but can the same be said for the reverse? I have 94 XL with manual windows. Is there existing wiring in the door of my XL manual window doors? Can I get the motors, regulators and swithes from XLT door and plug n play?

 

The wiring for pw is not there on manual window trucks so it is not plug n play.

 

still trying to figure out if the interior door panels of any f series truck will fit on the door of my 89 4 door f350.

 

87 to 91 f-series and bronco will exact fit.
92 and newer will sorta fit, but not exactly