Category: Engine - Exhaust
Price: $300
Private or Vendor Listing: Private Listing
Part fits (you may select multiples): Fit, S2000
Item Condition: IN
Engine: Part suitable for gas truck

I have a complete custom bent dual exhaust system with a flowmaster muffler for sale. It came off of a F150 with a 351w comes with everything from the Y pipe back to the tailpipes coming out the rear. I had it custom made for the truck and less than a month later the truck was damaged in a storm and totaled out. I removed the exhaust before it was taken for scrap. I have everything even the hangers and clamps to put it back on. It is a direct bolt in for any Ford truck from 80-97 and will probably fit other models as well. The exhaust is like brand new it hasnt even blued from the heat. This exhaust cost me over $700 when I got it installed I am just looking to make a little back out of it.

 

sounds very reasonable

 

Cannot use it anymore and I can't see letting it go to waste sitting in the rafters of the barn when someone could use it.

 

jeez wish you were closer and it was for a straigt 6. i just paid somebody to put new exhaust on my truck. too bad for your truck. tobad you couldnt salvage anything else from it.

 

I salvaged all kinds of stuff from it just tell me what you need. All you would have to do is weld the pipe up and it would have worked for a straight 6.

 

Bump back to the top

 

Back to the top

 

Still have it guys make me an offer.