Gear in differential case slipped out
#1
Gear in differential case slipped out
I have an 89' F-250 with the 10.25" rear end. I slid the pinion shaft out and the top pinion gear slid out. It doesn't want to go back in. It is engaged with both side gears but is off center and spins in place. Anyone have any bright ideas? Is there a trick to get it back in position for the shaft to go back in? Any help would be greatly appreciated.
Thread
Thread Starter
Forum
Replies
Last Post
eddieburnsii
Clutch, Transmission, Differential, Axle & Transfer Case
2
06-30-2007 09:02 PM
eldon
Clutch, Transmission, Differential, Axle & Transfer Case
2
11-27-2006 05:45 PM
ovaltrack
General Automotive Discussion
1
05-23-2006 09:46 PM
rparsons1000
Clutch, Transmission, Differential, Axle & Transfer Case
5
06-10-2002 06:05 AM
jim henderson
Clutch, Transmission, Differential, Axle & Transfer Case
2
04-25-2002 05:39 AM