I've done the solid axle swap, now I need to know how high it should sit front to back.
With the f250 2 inch blocks it sits about an inch high on the back. When I put my camper on it's low. When I used the 4 inch blocks it seemed too high.
Can somebody with a stock 350 with good springs tell me how much higher the body sits back to front.

 

My 1992 F350 4x4 w/5.8L engine and E4OD measures a difference of 3 inches front to back. I measured just behind the front and rear tires at the bottom of the front fender and rear panel.

 

Thankyou, very much. That's where it's at with the 4 inch blocks, so I'll be putting them back in.