Just found a Dana 60 from a single wheel crew cab. The guy wants 500 for it but told me atleast 7 times to make an offer. Bead blasted the tag and it said 3.54. So it will work for me. However he doesnt have calipers or outer hubs..Will my F250 hubs fit?

 

Yes, F-250 hubs will work. Even D-50 hubs will work!

 

Sweet! Any chance my calipers will fit? I know NOTHING about these

 

Yes, calipers will work as well.

 

what year is the front end?? myn was from a 93, and they use them metal pines with the rubber in the middle to hold on calipers and ares bolt on, it has 3.55 hu? wish i had them in stead of 4.10, but may hurt me with my 37s

 

It was from a 96 he said. Im going to buy it soon, and tear it all apart and sand blast and rebuild it all. Then throw it in over the winter.

 

ha, ya u dont want 3.55s with 37s. i had 38 tsl's and i would even put it into overdrive on the freeway

 

I ran 37's and 3.55's for several years. Got 4.10s now, but sure miss the 3.55's.

 

sounds like a good time to do the shackle reversal on the front.

 

you could but if he had the front end out and did the d60 it would be taller with the shackle flip? the d60 itself will level out a f250

 

Doesnt the reverse shackle kit make it ride better or something??

 

Supposed to. RSK and F350 rear blocks and you'll be level... supposedly. NOT in my case! Use the F350 springs.

 

my truck rides like a dream till you hit a bump!!!!

are you guys sure the d50 hubs will fit. i though the 96 97 king pins were different.

 

96 and 97 didn't use kingpins.

Dana 60's from the late 80's on are all balljoint

 

The rotors, calipers and hubs from a F250 (TTB D-50) are the same as the srw F-350 (D-60). I think even the spindles are the same. Go to a parts store and have them look up the p/n. They are the same. Brake pads are even the same.
Now the dually's are a different story.