waht cam should i use?
Thread Starter
|
Junior User
Joined: Feb 2006
Posts: 88
Likes: 0
From: Harrisburg area Pa.
waht cam should i use?
I have a 1976 F-150 with a 360 ci engine I recently bought a 600 cfm edlebrock
carb hooker headers and a few other odds and ends.
The block i scurrently at the machine shop and I am looking to buy a rebuild kit for it but I am not sure what cam to buy. I want to step it up from stock but at the same time i dont want to go to radical. can anyone help me?
carb hooker headers and a few other odds and ends.
The block i scurrently at the machine shop and I am looking to buy a rebuild kit for it but I am not sure what cam to buy. I want to step it up from stock but at the same time i dont want to go to radical. can anyone help me?
Posting Guru
Joined: Oct 2005
Posts: 1,235
Likes: 2
have you thought about turning it into a 390? same cost-after you get a crank and rods- and you can go with the same cam or even a bit larger than you'd use in the 360 and get more power and a better idle... just a thought.. post this in the FE enine forum and you'll get a ton of help!!! i would probably go with the crane 901 i a 360 though....
