More removed all 4 doors gutted. Still several hrs of work before she can leave. Gosh what am i doing?!?!?!

 

Building a dream. Just go with it

 

x2^^^^^^^^

 

Look great, keep going.

 

True story. I guess at this point I'm in deep enough its getting pretty goofy.

Pulled the little steps off tonight. I guess I'm going to weld up all the holes in the rockers and eliminate them. I'm not sure what I will replace them with tho.
Coul ,pass side and center firewall stripped. Drivers side of firewall tomorrow night and heat shields removal. Then I will start cleaning the bottom for paint and reseal all the seams after removing ALL the factory seam sealer. The sealer is cracking and falling off. The coul really was never painted from the factory so my hope is to seal everything up at one time so rust never gets a chance to get ahold. I have some Eastwood cavity sealer stuff I'm going to get the cab mounts and coup innerds sealed from the inside with...sheesh this has totally gotten out of hand...

 

I built a couple equipment stands with some old fork lift wheels pulled from the trash at work.

Love them zero $ garage outfitters

 

Nice equipment stands!

Are you able to mount your mirrors with the wing windows installed?

 

No the lower fasteners are down in the door so the wing would have to be out.

 

Nice. I tried real hard to make mine work without removing the wings as I have wiring going through for power and defrost, it was a lot of effort and I think there are better options. Yours look really nice.

 

Looking great man

 

thanks Adam. Man am I ready to turn the corner on this project.
​​​

 

Stripped and ready for cleaning/seam sealer removal. Mean green scrubbing to commence..

 

When you say details you say Aaron!

 

This is the truth! Saved my@$$ more then once!

 

Aww thanks for the compliment but I promise there are way more Intense than me. Kevin and Brian have some impeccable rides that my junk will never be close to. Just an old camper puller