Conversation Between Mark Kovalsky and 1youngblood
Showing Visitor Messages 1 to 8 of 8
  1. Mark Kovalsky
    10-10-2018 05:19 PM - permalink
    You're welcome! Luckily the hurricane didn't come within 500 miles of me.

    Mark
  2. 1youngblood
    10-10-2018 03:51 PM - permalink
    Mark I just want to thank you again for the help with my trans. I had some other issues with codes and misfires once I got it back together but I think I got everything ironed out now.Fixed a lot of other things while I was at it.Leaky manifold,shocks,u joint sand a tune up.Hope all is well with you and the hurricane. Thanks Sean Youngblood
  3. Mark Kovalsky
    09-24-2018 08:45 PM - permalink
    It might tee together with the transfer case. It's been a long time since I've done one, I don't really remember.
  4. 1youngblood
    09-24-2018 05:49 PM - permalink
    Thanks Mark vent line is all set.I am having a problem finding the rubber line that goes to the transfer case.I guess that is why I was thinking the vent line might go to the transfer case.Where does it come from? I saw the one on the front differential going up on the passenger side firewall.Sorry for the rookie questions.I have pulled a few Transmissions but they were on 2 wheel drive straight 6 f 150s they were easy. Thanks Youngblood
  5. Mark Kovalsky
    09-23-2018 09:03 AM - permalink
    That rubber line is a vent. It should go up on the firewall.
  6. 1youngblood
    09-23-2018 07:12 AM - permalink
    Mark seals and bushing are replaced.Transmission is back in the truck.Ready to install transfer case.Does the rubber line from the top of the transmission go to the transfer case ? I removed it when the trans was half way down and didn't get a good mental picture. Thanks Youngblood
  7. Mark Kovalsky
    09-12-2018 08:41 PM - permalink
    Tap it out from the back.
  8. 1youngblood
    09-12-2018 08:01 AM - permalink
    Re. 2004 f150 4.6 transmission leak. Mark I inspected the bushing behind the pump seal it is scored. What is the best way of removing it with basic tools ? from the front side or removing the pump and tapping it out from the back side ? Thanks Youngblood

All times are GMT -5. The time now is 01:58 PM.