Window handle
Thread Starter
|
New User
Joined: Oct 2007
Posts: 21
Likes: 0
Window handle
This is a stupid question, but how do you remove the window crank handle on these old trucks? I thought that there would be a small clip like on most cars but I can't see one.
I need to pull out the regulator to change the window.
Thanks,
Case1950
1947 Ford 1.5 ton, V8, 2 speed rear.
I need to pull out the regulator to change the window.
Thanks,
Case1950
1947 Ford 1.5 ton, V8, 2 speed rear.
Moderator
Joined: Nov 2001
Posts: 2,643
Likes: 35
From: Orange County, CA
The escutcheon (stainless or painted piece under crank) has a spring loaded piece, push it towards door. When you do that you will see a couple of small holes in the base of the window crank. There will be a pin that is in one of the holes, that pushes through. Use a piece of stiff wire or a skinny screwdriver to drive it through. Installation is just the exact opposite.
And just in case you need, the door handles are held on the exact same way.
And just in case you need, the door handles are held on the exact same way.
Thread
Thread Starter
Forum
Replies
Last Post
1950ford
1948 - 1956 F1, F100 & Larger F-Series Trucks
17
Sep 30, 2007 06:40 PM
texan2004
1948 - 1956 F1, F100 & Larger F-Series Trucks
7
Oct 26, 2005 04:21 AM
