EZ Wiring kit wire removal
Thread Starter
|
Posting Guru
Joined: Mar 2006
Posts: 1,849
Likes: 1
From: Massillon, Ohio
EZ Wiring kit wire removal
I have all the wires removed which I will not be using right now. I want to take them out of the back of the mini fuse panel, but I am having trouble. I see a u shaped clamp? gong down over the connector once I pulled the fuse out. What do I do next to get it to release the wire? I am going to go back out and pull the ones from the back tail section which I won't be using then check back in. It looks like it going to be an all nighter to get this done tonight. I wll check back in about 20 minutes or so. 6:15 my time now.
Roast em' if you got 'em
Joined: Mar 2005
Posts: 21,997
Likes: 9,886
From: Rio Rancho, NM
look down into the connector, at the back side of the "U" part of the terminal you will see a small rectangular notch in the housing, a small metal tab from the terminal locks into this area. Use a small pick or a pocket screwdriver or something similar and push down into the recess, then gently pull the wire out.
Bobby
Bobby
Postmaster
Joined: Sep 2006
Posts: 4,525
Likes: 1
From: oh
Kev--did you get the wreckr bed yet??How did it come out? Did he paint it too? Don't forget there is a long shaft with a gear on end that looks like it wraps up the cable on the wrecker,also there is a electric convertor or regulator with wires like starter connections that you will probably need.
I still am unsure of start time for Nat's.I won't be sure till a few days away.
I still am unsure of start time for Nat's.I won't be sure till a few days away.
Thread
Thread Starter
Forum
Replies
Last Post
laxdad
1999 - 2003 7.3L Power Stroke Diesel
2
Sep 18, 2015 11:50 AM
90pioneer
1999 - 2003 7.3L Power Stroke Diesel
7
May 9, 2015 11:44 AM
