Dana pinion depth markings
Thread Starter
|
Freshman User
Joined: Dec 2003
Posts: 29
Likes: 0
From: connecticut
Dana pinion depth markings
I am replacing the the R+P in my dana 70 dually (4.10 to 3.54)
My old pinion marking was +6 and my new one is +2.
On this rear the pinion shims are under the inner race rather than under the pinon bearing.
If the shims were under the bearing, I think I would remove 0.004. SInce they are under the race, I need to add 0.004".
Is this correct??? or am I backwards?
TIA
Sean
My old pinion marking was +6 and my new one is +2.
On this rear the pinion shims are under the inner race rather than under the pinon bearing.
If the shims were under the bearing, I think I would remove 0.004. SInce they are under the race, I need to add 0.004".
Is this correct??? or am I backwards?
TIA
Sean
Thread
Thread Starter
Forum
Replies
Last Post
farmnaggie
1973 - 1979 F-100 & Larger F-Series Trucks
2
Mar 8, 2012 09:43 PM
mortstang
Clutch, Transmission, Differential, Axle & Transfer Case
3
Mar 15, 2010 04:18 PM
