Pics please help, cant find clutch

Reply Subscribe

Thread Tools

Search this Thread

Dec 28, 2004 | 04:26 PM

Einzee

Thread Starter

New User

Joined: Dec 2004

Posts: 4

Likes: 0

*Pics* please help, cant find clutch

I have a major prob. I own a Ford V8 w/ T-18 trans. I can't get help from Autozone B/C the drivetrain is in a Jeep. Can someone please tell me what vehicles these tranny's came in? I will attempt to give as much info as possible: The side of the case says T18. The top cover says T98. The input shaft is 10 spline. The trans is coupled to a transfer case. The clutch disk is 11" Also I need to know the size of pilot bearing/bushing.

Last edited by Einzee; Dec 28, 2004 at 04:31 PM.

Dec 28, 2004 | 06:03 PM

IB Tim

FTE Leadership Emeritus

Joined: Jan 2003

Posts: 161,999

Likes: 75

From: 3rd Rock

Welcome to the only family Ford Truck site, on the net. The members in these forums are very knowledgeable about trucks; they will eagerly help you…with your question. If you have a minute check out the Guidelines, it will help you to navigate through FTE.
Enjoy FTE

Dec 28, 2004 | 07:00 PM

fordman300

Senior User

Joined: Aug 2003

Posts: 330

Likes: 0

From: clarks mills, PA

an 11 in clutch and pilot bearing from any truck with watever motor your running will fitjust fine as all gas trannys use a 1 1/16 10 spline input shaft.

is it a hydraulic or manual clutch

Dec 28, 2004 | 10:34 PM

Einzee

Thread Starter

New User

Joined: Dec 2004

Posts: 4

Likes: 0

its a hydraulic. Im looking specifically any model of vehicle that had v8 and this type tranny. Im replacing the clutch disk and pressure plate and autozone looks at me like im from another planet.

Dec 29, 2004 | 08:53 AM

greenhighboy

Elder User

Joined: Jul 1999

Posts: 877

Likes: 2

From: Missouri

Take your old parts to the store with you. If they still can't help,find another parts store. Buy the clutch to match the engine.

Dec 30, 2004 | 05:00 AM

754x4fordman

Junior User

Joined: Feb 2004

Posts: 91

Likes: 0

From: Ohio

unless its a 1975 ford that had a 300 six then a rebuilt 390 with a 360 flywheel... just ran into that over the weekend...after 3 trips to the parts store...
by the way autozone sucks! i quit dealing with the fools there a while ago and went to advanceauto. just my 2 cents...ha ha