Do I have to Remove the Oil Pan
Thread Starter
|
Cargo Master
Joined: Sep 2004
Posts: 2,691
Likes: 6
Do I have to Remove the Oil Pan
Radiator and water pump are both leaking so I pulled them both out. Timing cover leaks oil like a **** so I thought I'd gasket that up and replace the timing chain and gears.
Do I have to remove the oil pan to do so? Shop manual says to do so but I'd rather not if I don't have to.
EDIT: n/m I found this
Do I have to remove the oil pan to do so? Shop manual says to do so but I'd rather not if I don't have to.
EDIT: n/m I found this
Last edited by qman; May 10, 2026 at 12:08 PM.
Fleet Mechanic
Joined: Aug 2007
Posts: 1,829
Likes: 256
From: Piney Woods of East Texas
No you don't need to remove the pan but you will need to use enough sealant to seal the corner when you put it back together. If I recall some of the bolts holding the cover on goes into a water passage so sealant will be needed on a those 1-2 bolts.
Hotshot
Joined: Jul 2020
Posts: 10,471
Likes: 2,633
From: Near Salt Lake City
You will find it about impossible to just push the front cover on there with the oil pan in place, and a new end seal in the cover
I've been known to file 13 the end seal and use straight silicone for the end seal
Then that cover pushes right on there
I've done it both ways
Just push down real hard and the dowl pins will align and you can push the cover in
Sometimes that squashes out the gasket and the silicone you need
Best of luck, you can do it
I've been known to file 13 the end seal and use straight silicone for the end seal
Then that cover pushes right on there
I've done it both ways
Just push down real hard and the dowl pins will align and you can push the cover in
Sometimes that squashes out the gasket and the silicone you need
Best of luck, you can do it
Thread
Thread Starter
Forum
Replies
Last Post
mrlj22
1987 - 1996 F150 & Larger F-Series Trucks
27
Sep 25, 2015 09:24 AM
petel
Big Block V8 - 385 Series (6.1/370, 7.0/429, 7.5/460)
3
Dec 13, 2000 06:35 PM
