Flareside bed drawing?
Thread Starter
|
Senior User
Joined: Apr 2012
Posts: 324
Likes: 0
From: Spencer Mountain, NC
Flareside bed drawing?
Does anyone have a good drawing showing orientation of all the Flareside bed components? Will soon be reassembling my donor bed and am unsure of the correct location of the underside support pieces. PO had replaced several of the underside support pieces with Uni-Strut. I now have all the correct pieces. Thanks in advance for any and all assistance.
Moderator & parts slinger
Joined: Feb 2007
Posts: 50,205
Likes: 5,797
From: S/W Missouri, Polk county
Stand by Number Dummy, mike o0o0o0 or some one will post up a pic here soon. This is all I have for now, yes not quite what you need, but close to what you will be getting.
Fleet Mechanic
Joined: Sep 2012
Posts: 1,608
Likes: 53
Thanks Mike. I know I can find it on my disc but its good to have it here also. Thanks
Canus, I will be starting my bed in about a month, I may ask questions. I have been saving information for when the time comes.
Subscribed for future use.
Canus, I will be starting my bed in about a month, I may ask questions. I have been saving information for when the time comes.
Subscribed for future use.
Thread Starter
|
Senior User
Joined: Apr 2012
Posts: 324
Likes: 0
From: Spencer Mountain, NC
Thanks Mike. This will help a lot. Still have to figure out exactly where underside cross braces attach to side panels but can probably figure that out by trial and error.
Thread
Thread Starter
Forum
Replies
Last Post
