Shifter boot installation 1950 f1 3 speed
Thread Starter
|
Senior User
Joined: Jul 2003
Posts: 194
Likes: 1
Shifter boot installation 1950 f1 3 speed
I am at the point where I need to figure out the access cover seal to transmission and shift boot. I had a t-9 and I am now going with a top loader 3speed. My truck was missing the shifter boot when I got it so I don't know if the boot sits directly on the metal access cover (no screws). And the floor mat gets trimmed around the boot? I can't imagine the boot going over the mat unless I am missing a trim ring or something.
Also my t9 had a metal plate that sat on top of the shift tower that held the bottom of the thick gasket sealing to the access cover. Is the 3 speed a different plate? Is it necessary?
Anyone have pictures of original install they can share with me?
Also my t9 had a metal plate that sat on top of the shift tower that held the bottom of the thick gasket sealing to the access cover. Is the 3 speed a different plate? Is it necessary?
Anyone have pictures of original install they can share with me?
Thread
Thread Starter
Forum
Replies
Last Post
Aaron81
1948 - 1956 F1, F100 & Larger F-Series Trucks
16
Mar 17, 2019 07:07 AM
Vegas123
1948 - 1956 F1, F100 & Larger F-Series Trucks
7
Apr 28, 2015 02:10 PM
60'_f100
1957 - 1960 F100 & Larger F-Series Trucks
8
Feb 6, 2015 03:44 PM
fordxxx
Clutch, Transmission, Differential, Axle & Transfer Case
6
Dec 1, 2005 07:34 PM
cbfomoco
1948 - 1956 F1, F100 & Larger F-Series Trucks
3
Oct 19, 2005 11:27 AM
