Replacement Manifolds
Thread Starter
|
New User
Joined: Jun 2010
Posts: 17
Likes: 0
Replacement Manifolds
Any opinions on these, or would they be considered junk and something I'm going to have to replace again in the near future?
Car Part Wholesale - Auto Parts and Accessories Catalog - Exhaust Manifold For 1998 Ford F-150 XLT 8 Cyl 5.4L
Also, any input as far as a copper manifold gasket, or fel-pro, or OEM??
Car Part Wholesale - Auto Parts and Accessories Catalog - Exhaust Manifold For 1998 Ford F-150 XLT 8 Cyl 5.4L
Also, any input as far as a copper manifold gasket, or fel-pro, or OEM??
Thread Starter
|
New User
Joined: Jun 2010
Posts: 17
Likes: 0
I've really been thinking about some headers, but would like to keep costs down as much as possible and I don't know if I want to tackle the drivers side manifold removal either at this time.
Increased costs of the replacement stainless studs for that side and the one EGM or whatever that sensor is as it's completely corroded, plus the extra for the headers even though I'd like to go that route.
I ended up having to cut six out of the eight nuts off the passengers side manifold and came really really close to not being able to remove the last stud without having my truck towed somewhere for assistance.
I'm ready to just get this tied up and move onto the next frustration (Spark plug replacement)
I've got a few other projects that require funds as well at this time and I'm trying to save for a hunting trip.
Fleet Mechanic
Joined: Sep 2003
Posts: 1,716
Likes: 15
If I needed a new exhaust manifold, I would use the ones made by Dorman. Dorman (RB Industries) is an Original Equipment Manufacturer, suppling parts to many auto manufacturers. I have used a lot of their parts. They also make improved design parts for certain situations.
I would also use the gasket that comes with the manifold kit, not substitute something else for it. And like all castings, I would torque it properly, in the pattern/steps/torque levels specified.
"No name" or cheesy marketing name parts with lower prices are probably made in China, I would not touch them.
I would also use the gasket that comes with the manifold kit, not substitute something else for it. And like all castings, I would torque it properly, in the pattern/steps/torque levels specified.
"No name" or cheesy marketing name parts with lower prices are probably made in China, I would not touch them.
