Another Drive Shaft Thread
Thread Starter
|
Senior User
Joined: Feb 2005
Posts: 294
Likes: 0
From: Tillamook, Or.
Another Drive Shaft Thread
I didn't want to hijack DirtMcGit's drive shaft thread but I too have a drive shaft question.
I have read the Sticky in the Technical Information area and understand the problem that the 96 and up Drive shaft has. I haven't found a 4" Aluminum drive shaft to replace mine with but I am expecting it to be a very expensive upgarde.
My question is whether anybody in this forum has tried machining and threading a grease fitting into the slip joint? Is there a reason not to at least try?
Thanks
I have read the Sticky in the Technical Information area and understand the problem that the 96 and up Drive shaft has. I haven't found a 4" Aluminum drive shaft to replace mine with but I am expecting it to be a very expensive upgarde.
My question is whether anybody in this forum has tried machining and threading a grease fitting into the slip joint? Is there a reason not to at least try?
Thanks
