Finished Some Mods Today........
#1
Finished Some Mods Today........
Seen this on an older post. Did Clays truck first, then mine.
This is the 1"x1/8" pice of flat stock I used to support the antennea. Solid as a rock.
Finnaly got my pre-filter in. Not happy with the bracket, but it was hot, and I was lazy. I'll build something better later.....
This is the 1"x1/8" pice of flat stock I used to support the antennea. Solid as a rock.
Finnaly got my pre-filter in. Not happy with the bracket, but it was hot, and I was lazy. I'll build something better later.....
#7
Trending Topics
#8
#10
#11
Looks good buddy! I was sold as soon as you sent me the thread link last week.
Is that the Firestik you told me about? Is that a 4' or 5'?
I'm also looking hard at different single din size CB's to mount in the dash like you suggested from that same thread.
I plan on making a new thread asking for input once RRE is finished and most of the guys are home.
Is that the Firestik you told me about? Is that a 4' or 5'?
I'm also looking hard at different single din size CB's to mount in the dash like you suggested from that same thread.
I plan on making a new thread asking for input once RRE is finished and most of the guys are home.
#12
#13
#14
Thanks for the pic! That's not bad at all, I have my gauges there too. Hell I even have the AC gauge in the same vent, Haha. Thanks again.
#15
Here's the grocery list for the pre-filter:
Baldwin filter base part number- FB1311
Baldwin filter part number- BF1212
I picked up the fittings at my local hydraulic shop. I believe they are 6an. I ran 3/8 hose from my tank to my pump many moons ago on the advice from Dan (kwikordead) I believe.
Baldwin filter base part number- FB1311
Baldwin filter part number- BF1212
I picked up the fittings at my local hydraulic shop. I believe they are 6an. I ran 3/8 hose from my tank to my pump many moons ago on the advice from Dan (kwikordead) I believe.