Torque and sequence info needed
Thread Starter
|
Elder User
Joined: Sep 2008
Posts: 670
Likes: 0
From: Federal Way Wa
Torque and sequence info needed
I have a 352 and I'm putting new heads on. I need to know the tightening sequence and torque settings for the heads and the intake/exhaust manifolds. Having a little trouble finding them. Thanks
Rob
Rob
Logistics Pro
Joined: Oct 2005
Posts: 3,785
Likes: 4
From: Mddl A MexCans
Heads: Top row is odd #'s bottom row even #'s center top is #1 work your way through it in an outward spiral. I usually start at 50lbs and go up in 15lb increments to 95lbs.
Intake:
rear of intake drvr side (4,7,1,9,6)
rear of intake pass side (5,10,2,8,3) snug the 32-35lbs
exhaust manifolds: center out spiral 18-24lbs
Intake:
rear of intake drvr side (4,7,1,9,6)
rear of intake pass side (5,10,2,8,3) snug the 32-35lbs
exhaust manifolds: center out spiral 18-24lbs
Logistics Pro
Joined: Oct 2005
Posts: 3,785
Likes: 4
From: Mddl A MexCans
I have a new set (in the box) I'll let go for real reasonable! PM me if interested. Think they were $45 at NAPA new. Probably better off with the normal exhaust gaskets and forget the heat shields. IMO
Thread Starter
|
Elder User
Joined: Sep 2008
Posts: 670
Likes: 0
From: Federal Way Wa
I think that's what I'm going to do. and I just realized i have a complete gasket set so I'm going to go ahead and replace the timing gears and chain while I have it apart this far. Hoping i can get the pan out without removing the motor all the way.
Thread
Thread Starter
Forum
Replies
Last Post
California Codfish
1961 - 1966 F-100 & Larger F-Series Trucks
11
Sep 19, 2023 04:08 PM
oldtexasdog
1967 - 1972 F-100 & Larger F-Series Trucks
2
Sep 22, 2011 10:09 AM
DavOliv
Big Block V8 - 385 Series (6.1/370, 7.0/429, 7.5/460)
1
Mar 5, 2011 02:51 PM
rustyolred27
Ford Inline Six, 200, 250, 4.9L / 300
3
Apr 26, 2009 05:53 PM
