Front end service
Thread Starter
|
Senior User
Joined: Jan 2004
Posts: 349
Likes: 0
From: MN
Front end service
I am replacing the front rotors at 90,000 miles. Is there any front end service I should be doing, while I am working out front?
Also I have electronic shift on the fly and must have a vacuum leak, is there anything I should check while I am at it?
Also I have electronic shift on the fly and must have a vacuum leak, is there anything I should check while I am at it?
New User
Joined: Mar 2008
Posts: 7
Likes: 0
From: West Louisiana
with 90,000 miles, you should probably check the whole setup. NOT saying anything is bad, but it couldnt hurt to check. Once the caliper and rotor are off, see if you have any play in the wheel hub, also grab the tie-rods and see if there's play in them... it all should be pretty solid. If you're not in the habit of greasing the fittings on the front end, I'd recomend that too, I usually check the grease fittings every oil change.
