1939 ford question

Reply Subscribe

Thread Tools

Search this Thread

May 21, 2009 | 08:03 PM

Magic

Thread Starter

Junior User

Joined: Aug 2002

Posts: 80

Likes: 0

From: Waimalu,Hawaii

1939 ford question

Don't laff and tell me this is a Ford truck website,I know that. But I have to ask. I have searched dennis carpenter, C &G, Early Ford, Ebay, Hemmings,craigslist and may more. But for some reason I cannot find something as simple as a 1939 Ford Car horn button spring. I am not sure if the 39 truck is the same. I know the 1940 car & truck are diffrent then the 39.
This is a total orginal 1939. Anyone with ideas ???
THANKS !!!!!!

May 24, 2009 | 09:50 AM

harley dude

Junior User

Joined: Jul 2008

Posts: 96

Likes: 0

i have an old book of Tom Meyer v-8 ford 608-835-8833. they list a spring.. just not sure if they are still in the parts buss. good luck

May 25, 2009 | 06:32 PM

Magic

Thread Starter

Junior User

Joined: Aug 2002

Posts: 80

Likes: 0

From: Waimalu,Hawaii

Thanks Harley ! I will give them a call. Ill let you know.

May 26, 2009 | 10:58 AM

harley dude

Junior User

Joined: Jul 2008

Posts: 96

Likes: 0

looking in my 38 file and found a few more...kenroy antigue ford parts 609-848-4887 after 7 pm........trautwein products early ford parts 518-677-5668........valley antique ford 215-767-8437...... these were some old contacts i had for my truck hope you find your part

Jun 20, 2009 | 02:48 PM

moseyboy

New User

Joined: Jun 2009

Posts: 2

Likes: 0

I have a 38 Cabover, had the distributors rebuilt, all valve are free, has spark, motor spins nice but I can't get it to fire, any ideas on what to , TIim

Jun 22, 2009 | 01:43 PM

harley dude

Junior User

Joined: Jul 2008

Posts: 96

Likes: 0

have you pulled a plug to see if you have spark. anyback fire at all.? are you sure your getting gas?

Jun 22, 2009 | 06:56 PM

manyolcars

Junior User

Joined: Oct 2003

Posts: 52

Likes: 0

did you time it with cylinders 1-4 on the right bank?

Trending Topics

1985 F250 4.9 i6 Fuel Pump Replace

78

984
7.3 or/vs 6.7

67

3.3k
Axle flip. Yay or nay?

23

499
Fords V8 gas competition

19

569
Two Months In.... It's Changing Me

23

923

Jul 4, 2009 | 10:28 AM

moseyboy

New User

Joined: Jun 2009

Posts: 2

Likes: 0

OK guys, I got the poop on my set-up, I have the domed dist that is setup and strobed on the bench, according to the guys that did it there is no more to do, my initial thought was this has to be 180 degrees off but the offset on the dist and cam can only go together one way so that can't be the problem, anybody have any ideas what I should check next, The gas tank is rusty so I've been trying to start by pouring a little gas in the carb, so assuming I have spark and the wiring is right shouldn't the truck at least fire, any thoughts on this greatly appreciated, moseyboy