Hot start problem
Thread Starter
|
New User
Joined: Apr 2009
Posts: 3
Likes: 0
Hot start problem
2006 F250, when vehicle is a normal operation temp and I shut down it will not start until it has cooled abou 30 -45 minutes. It spins over very well but acts as if it is not getting fuel. After cooling as indicated above it then starts normally. 
FTE Leadership Emeritus
Joined: Sep 2003
Posts: 12,253
Likes: 763
From: Houston, Texas
Sounds like your STC fitting or Snap To Connect fitting on your HPOP. When your engine is cold, the oil is thicker allowing it build the necessary pressure to start. When your engine is hot, your oil is thin making it more difficult if not impossible to start. If you're still under warranty, there's a bracket they install that will rectify the problem.
Posting Guru
Joined: May 2003
Posts: 1,990
Likes: 1
From: Middleburg, FL
Here's a link to a good article on the STC fitting:
http://www.forddoctorsdts.com/articl...icle-07-08.php
http://www.forddoctorsdts.com/articl...icle-07-08.php
