I"m having new drivelines built, and while i'm at it, i'm thinking of replacing the rear input yolk on the ford 9 inch rearend. I want a big and beefy one, not the puny little one that is currently on it. I want a strong u joint. Help?

 

you might try going to drive shaft for largercross pin diameter and cross length. DRive shaft spec -NAPA OWNED Columbus joint &clutch ohio People who carry Spicer DAna probably best

 

[updated:LAST EDITED ON 15-Mar-02 AT 08:12 AM (EST)]http://dennysdriveshaft.com/ tell him Bill Anthony sent you

He's right around the corner from me and builds bullet proof stuff.