slave question
Thread Starter
|
Postmaster
Joined: Sep 2008
Posts: 2,995
Likes: 0
From: raymond alberta
slave question
what can cause a slave to wear out stupidly fast?...i put a new slave in my 95 sometime between oct. 29th and nov. 7th 2008 and now its shot again? silver auto said he will warranty it and im fixing it monday but i was thinkin there might be something deeper in the truck causing it to wear out fast or just faulty slave? 
thanks guys
thanks guys
Post Fiend
Joined: Jan 2005
Posts: 8,402
Likes: 10
A real downer. A few thoughts, excessive high fluid pressure caused by bad clutch or worn/sticking throwout bearing carrier (you would notice this in high force required to depress pedal). Bad fluid. Or, most common cause, poor cylinder manufacture. Also if a concentric type may be caused by excessive vibration due to bad transmission shaft nose bearing or case bearing of excessive heat from slipping clutch.
All I can think of at this time. Hope it helps.
All I can think of at this time. Hope it helps.
Thread Starter
|
Postmaster
Joined: Sep 2008
Posts: 2,995
Likes: 0
From: raymond alberta
well clutch was new when i bought the truck clutch was nice and smooth nothing was slipping but i THINK the syncros in the trans are shot i and i put new shift forks in when i did the slave last time and the one was almost worn through when i had the rear cover and tail off my t-case i noticed the shaft was kind of wobbly but since the rear cover has a bearing in it i didnt think it was serious i dont know how the shaft on the trans. is when i get it all out monday ill take a good look at it see if i can find anything
thank you for your help man that will help now i know a bit more to look for
thank you for your help man that will help now i know a bit more to look for
