I'm having some issues with 9.75
Thread Starter
|
New User
Joined: Jan 2008
Posts: 7
Likes: 0
I'm having some issues with 9.75
I bought new parts and all new bearings and axles, I then disassemble the truck and start putting putting it all back together come to find out that the old axles and shot. This is were I start having problems, the axles are larger then the old ones about .050" larger I cant get the bearings to fit on them not even the old bearings. I can only get them to slip half way down the axle. The axles seam to be the same length.
Truck is a 2000 f 150 with 5.4 9.75 rear
Truck is a 2000 f 150 with 5.4 9.75 rear
Thread Starter
|
New User
Joined: Jan 2008
Posts: 7
Likes: 0
Did the axle tube stay the same? could I get a different year bearing?
Posting Guru
Joined: Dec 2006
Posts: 1,466
Likes: 0
From: N. Fort Myers,FL
Im not exactly sure. Go to your local autoparts store and buy two bearings for like an '02 9.75. Dont install them into the housing until you are sure they will work, once installed it is very hard to remove them without damaging them.
Let us know what you figure out.
Let us know what you figure out.
