O2 sensor connector
Thread Starter
|
Senior User
Joined: Apr 2007
Posts: 123
Likes: 0
From: northeast Pa
O2 sensor connector
I need to repair the upstream O2 sensor connector on the drivers side. While working on the exhaust gaskets I broke a wire inside by pulling on it. The schematic shows it plugs into another 8 pin wire harness somewhere behind the engine on the passenger side. I can't find it. Anyone know where it is & how to get at it?
Thread Starter
|
Senior User
Joined: Apr 2007
Posts: 123
Likes: 0
From: northeast Pa
yes it is but it is very tight working conditions. I can barely get a hand in there to disconnect the o2 sensor. I was hoping someone knew where the lead in to the connector was so I can disconnect it at the source if it is more readily available. It looks like it is fed from the passenger side.
Thread
Thread Starter
Forum
Replies
Last Post
timbersteel
1987 - 1996 F150 & Larger F-Series Trucks
2
Nov 2, 2010 03:24 PM
jmfay
Explorer, Sport Trac, Mountaineer & Aviator
3
Jun 11, 2006 11:06 AM
geoaigel
1983 - 2012 Ranger & B-Series
3
Jan 10, 2005 10:50 AM
