Problem with ignition
Post Fiend
Joined: Oct 2005
Posts: 5,242
Likes: 0
From: Kiev, Ukraine
my e-mail 2005pa@mail.ru.
Well, who has a good manual to read codes, I gonny try to translate it for Mardan
Well, who has a good manual to read codes, I gonny try to translate it for Mardan
Post Fiend
Joined: Oct 2005
Posts: 5,242
Likes: 0
From: Kiev, Ukraine
Ok, I try to tell how to pull codes... first of all have 2 m wires and switch. connect them to OBD-II connector as shown at picture in manual above, run engine and close switch from cabine. You'll get current codes. Wright down blink codes (Chek engine light blinks, usually 3 digit codes, but 2 dig. codes on early aeros). Open switch at running engine (clearing codes), ride and pull codes againe. I suggest you may have bad MAF, bad fuel pump, clogged filtres , dirty fuel sender, bad wires/spark plugs/coils... well, pull codes first!
Thread
Thread Starter
Forum
Replies
Last Post
George Frasier
1973 - 1979 F-100 & Larger F-Series Trucks
10
Jul 18, 2010 06:19 PM
