Crank snout solutions
Thread Starter
|
Junior User
Joined: Aug 2006
Posts: 66
Likes: 0
Crank snout solutions
"One thing, when the boost gets up high, the V10 crank snout likes to fall off
Someone does make a bearing support for it though."
__________________
Any ideas where to look for a solution??
Someone does make a bearing support for it though."
__________________
Any ideas where to look for a solution??
FTE Leadership Emeritus
Joined: Jul 2002
Posts: 42,561
Likes: 423
From: Long Island USA
I don't remember ... there's a few thread a few years back about it.
OK, found something on the Ford fleet site:
https://www.fleet.ford.com/TRUCKBBAS/non-html/Q62.PDF
OK, found something on the Ford fleet site:
https://www.fleet.ford.com/TRUCKBBAS/non-html/Q62.PDF
FTE Leadership Emeritus
Joined: Jul 2002
Posts: 42,561
Likes: 423
From: Long Island USA
Truth be told, I was amazed I found that - Google to the rescue.
I personally never knew Ford actually wrote something up about it. Nor that they actually had a part number for it.
I'm not sure this is what was talked about as a snout support for a supercharger though.
But it IS interesting nonetheless.
I personally never knew Ford actually wrote something up about it. Nor that they actually had a part number for it.
I'm not sure this is what was talked about as a snout support for a supercharger though.
But it IS interesting nonetheless.
