When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I started installing subs and had to pull up the rubber mat and found dirt packed along the rail inside the drivers side, had to break up the dirt and get it vac'd out. And what did i find, RUST. So now I have to go get some rustolium primer do some painting. So she's side lined for now.
replaced the passenger side outer tie rod end, and the blower resistor. Had to cut the old resistor off as the yellow wire burned up and would not pull off. Spliced in some extra wire and a heavy spade connector. Its nice to finally have all 4 fan speeds working, and tighter steering that doesn't skip on me
installed the drivers side leather explorer/bronco seat track combo. will install the other tommorow and tie up oher loose ends, and install the exhaust, hopfully get it mobile,
Mounted the Maglight recharger in the new rollback. I put it alongside the drivers seat just inside the door so its easy to grab on the way out of the cab.
replaced the passenger side outer tie rod end, and the blower resistor. Had to cut the old resistor off as the yellow wire burned up and would not pull off. Spliced in some extra wire and a heavy spade connector. Its nice to finally have all 4 fan speeds working, and tighter steering that doesn't skip on me
Don't feel bad, your not the only one. I had to do the samething.
new motor mounts, new bell housing, new radiator, put the engine back where it belongs. tomorrow the bumper gets pounded back into shape and maybe repainted.
new motor mounts, new bell housing, new radiator, put the engine back where it belongs. tomorrow the bumper gets pounded back into shape and maybe repainted.
Glad to here that your truck is getting repaired,just got new tires for my truck,should have them mounted this week.