TQ converter

Reply Subscribe

Thread Tools

Search this Thread

Jul 10, 2002 | 03:50 PM

mcguyver

Thread Starter

Junior User

Joined: May 2002

Posts: 90

Likes: 0

From: Eudora USA

TQ converter

Well once agin I made a stupid mistake. When i built my motor(400) I stabed her in useing a TCI breakaway (2400) stall. Puting in that motor was a pain in the ***. Now gust a few months of cussing at it I finally admit I should of used a Streetfighter(3000) stall. So my qestion is this should I go thru the pain of pulling and stabing the motor agin or can I just move the C-6 back. have any one here ever done it that way? Would it be easyer? harder?

Thanks.

-jim

Jul 11, 2002 | 10:05 AM

beartracks

Lead Driver

Joined: Nov 2000

Posts: 6,637

Likes: 349

From: Albuquerque

TQ converter

I'd rent a tranny jack and get the truck fairly high off the ground. Should be a lot easier than pulling the engine. Let us know if you change as to the diffence.

Jul 11, 2002 | 03:21 PM

mcguyver

Thread Starter

Junior User

Joined: May 2002

Posts: 90

Likes: 0

From: Eudora USA

TQ converter

Reply Subscribe

Reply Share

First
Prev
1 / 1
Next
Last

Forum Jump