head milling
Thread Starter
|
Junior User
Joined: Mar 2002
Posts: 93
Likes: 1
From: Montrose USA
head milling
Hi all,
Does anyone know how to tell how much material has been shaved off of a set of heads? Where would you measure from and what are the specs on that measurement? Thanks for any info.
Does anyone know how to tell how much material has been shaved off of a set of heads? Where would you measure from and what are the specs on that measurement? Thanks for any info.
Elder User
Joined: Feb 2001
Posts: 829
Likes: 0
From: Porterfield
head milling
>Hi all,
>
>Does anyone know how to tell how much material has been
>shaved off of a set of heads? Where would you measure from
>and what are the specs on that measurement? Thanks for any
>info.
There's a casting mark on the chamber side of the head that's .030 indent, by using a dial indicator you can measure how much has been milled off.
>
>Does anyone know how to tell how much material has been
>shaved off of a set of heads? Where would you measure from
>and what are the specs on that measurement? Thanks for any
>info.
There's a casting mark on the chamber side of the head that's .030 indent, by using a dial indicator you can measure how much has been milled off.
Lead Driver
Joined: Nov 2000
Posts: 6,636
Likes: 349
From: Albuquerque
head milling
...You have my attention as to measuring head volume/how much had been milled off, but I don't quite understand where the reference mark is and how you measure it.
A small point for a regular vehicle but we drive FORDS!
A small point for a regular vehicle but we drive FORDS!
Thread Starter
|
Junior User
Joined: Mar 2002
Posts: 93
Likes: 1
From: Montrose USA
head milling
looking at the chamber side of the heads there are reliefs at the corners. I am guessing these are the marks that you are talking abotu but they measure about .075 deep. Is there another mark that am supposed to be looking for? Thanks for the information.
Freshman User
Joined: Sep 2002
Posts: 33
Likes: 0
From: Orange county NC
head milling
It is a half moon indent, about in the middle, on the outside edge of the head on the combustion chamber side. However, it is a lot deeper than .030. I had one set of cleveland heads milled .050 and there is still about .020 left there.
Thread
Thread Starter
Forum
Replies
Last Post
*2fords*
Bed Covers, Tonneau covers, Toppers/Canopies & Bed liners
2
Dec 10, 2010 10:21 AM
werkdatool
335 Series- 5.8/351M, 6.6/400, 351 Cleveland
2
Aug 20, 2002 03:42 AM
