Hi,
Thread Starter
|
New User
Joined: Feb 2008
Posts: 1
Likes: 0
Hi,
Hi everyone, I'm a new member living in Australia. I have just obtained my first Ford. It's a '72 F100. It is fitted with a 302 Windsor but I'm fitting the old 300/6 back into it as everyone here sticks V8s into their vehicles. Has anyone made a twin carby inlet manifold and extractors for the 6? I can't find any information in Australia. I'm off to wor, will log on again tonight.
Cheers!
Dutchy.
Cheers!
Dutchy.
Post Fiend
Joined: Feb 2000
Posts: 11,496
Likes: 6
From: Kansas
Welcome Dutchy! 
Here are a couple of links to get you started: https://www.ford-trucks.com/forums/forum52/ and https://www.ford-trucks.com/forums/forum39/ Either one of those should put you in contact with those that can help. Speaking of help, we have a lot of folks from down under and you can meet them here: https://www.ford-trucks.com/forums/forum141/
Enjoy the site!
Here are a couple of links to get you started: https://www.ford-trucks.com/forums/forum52/ and https://www.ford-trucks.com/forums/forum39/ Either one of those should put you in contact with those that can help. Speaking of help, we have a lot of folks from down under and you can meet them here: https://www.ford-trucks.com/forums/forum141/
Enjoy the site!
Thread
Thread Starter
Forum
Replies
Last Post
