painlesswiring?
Thread Starter
|
Senior User
Joined: Nov 2002
Posts: 269
Likes: 0
From: loveland, co.
painlesswiring?
Do any of you guys have any experience dealing with the PainlessWiring EFI harnesses. I'm doing a 351W install into an early Bronco. The donor motor is out of a '92 F-150 with multi-port EFI.(I have the whole truck a my disposal!) Just looking around at the cost of converting the W to a carburated set up will cost about as much as a harness. I'd like the motor to stay stock, use the factory ECM, and have the Bronco be DD reliable. Any thoughts? Are they plug-n-play? Lastly, who's a good vendor? I've seen them selling online anywhere from $199 to $750. Thanx!
Hotshot
Joined: Jul 2002
Posts: 14,285
Likes: 12
From: Bend,OR
i would only buy a harness from these guys. http://www.flowmanagementunlimited.com/
second the efi from that 92 f150 is speed density and frankly not worth using. I would definatly go efi with your setup, just get a harness from above link and get a mustang a9l,a9p computer to manage it all.
second the efi from that 92 f150 is speed density and frankly not worth using. I would definatly go efi with your setup, just get a harness from above link and get a mustang a9l,a9p computer to manage it all.
