B&W turnover install - NEED HELP!

Reply Subscribe

Thread Tools

Search this Thread

Sep 28, 2010 | 05:56 AM

#16

Hardrocker

New User

Joined: Sep 2010

Posts: 13

Likes: 0

From: Minnesota

Quote:

Originally Posted by Mystic_Cobra

No, I should have specified. The 7-pin extension harness did not come with the hitch, I ordered it separately.
And thanks for the reminder on retorquing those bolts.

Where did you get the extension harness?

Was it a simple plug-in, or did you have to splice wires?

Where did you install the receptacle within the bed?

Can you provide a photo?

Sep 28, 2010 | 03:42 PM

#17

Mystic_Cobra

Elder User

Joined: Sep 2004

Posts: 543

Likes: 0

From: Northern VA

The harness came from e-trailer.com. It was a simple plug in. The factory harness unplugs from the connector at the rear bumper. The new harness is a splitter / Y-adapter type setup. You plug it into the bumper connector, the bumper harness, and then run the other end along the frame up into the side of the bed. I drilled a hole just in front of the left fender well in the bed and installed it there.
It came out nice. I'll see if I can get a pic.