Tie Rod

Reply Subscribe

Thread Tools

Search this Thread

Nov 18, 2007 | 11:45 AM

Soeedhawk

Thread Starter

New User

Joined: Nov 2007

Posts: 4

Likes: 0

Tie Rod

Hi there, wondering if one of you Ford guru's can help me out. I own a jeep cherokee, they guy I bought it from did a bit of a custom build on it. Anyway he used ford tie rods on it. He told me they were out of a 79 f100. But when I ordered a new one in it's about 8" to long (long end). Everything else seems to be correct. Anyone have an idea on what this tie rod came out of?

Thanks
Andrew

Nov 18, 2007 | 11:52 AM

Mil1ion

New User

Joined: Jan 2008

Posts: 0

Likes: 24

Welcome to the site.
This would have been better in the GAD forum as it is just a part ID.

Check on this page

http://www.rockauto.com/catalog/x,ca...,parttype,7428

Nov 18, 2007 | 12:00 PM

Soeedhawk

Thread Starter

New User

Joined: Nov 2007

Posts: 4

Likes: 0

Quote:

Originally Posted by Mil1ion

Welcome to the site.
This would have been better in the GAD forum as it is just a part ID.

Check on this page

http://www.rockauto.com/catalog/x,carcode,1121027,parttype,7428

Sorry, being my first post, I wasn't quite sure where to put this. If a mod wants to move it, it's fine by me.

Thanks for that link, if they gave dimensions there I would be able to figure it out.

Last edited by Soeedhawk; Nov 18, 2007 at 12:15 PM.

Nov 18, 2007 | 12:34 PM

Mil1ion

New User

Joined: Jan 2008

Posts: 0

Likes: 24

Is there not a stamping of a part # on it ?

The application chart should help.

I have a book on them but no measurements.

What side is it on ?

Inner or outer ?

Sealed Power #'s for tie rod assembly
Passenger side
#804-807

Driver's side Outer
# 804-806

Driver's side inner
#802-413R

Last edited by Mil1ion; Nov 18, 2007 at 12:38 PM.

Nov 18, 2007 | 09:38 PM

Soeedhawk

Thread Starter

New User

Joined: Nov 2007

Posts: 4

Likes: 0

It's the right inner, i will take a look for a stamping on it tomorrow. Thanks

Nov 19, 2007 | 09:12 AM

rebocardo

Post Fiend

Joined: Jun 2002

Posts: 13,873

Likes: 3

From: Atlanta GA

If he said "F-100" I would be more inclined to think 1972-1977.

Nov 19, 2007 | 09:43 AM

Soeedhawk

Thread Starter

New User

Joined: Nov 2007

Posts: 4

Likes: 0

Any idea where the stamped part # would be? I tried looking put didn't notice any stampings on it, could be due to dirt and corossion.

The tie rod I need should be 45" - 46" long