king pins again
Thread Starter
|
Freshman User
Joined: Jul 2005
Posts: 40
Likes: 0
From: glenwood springs colorado
king pins again
hi all,
so i've gotten the right king pin out and am moving on to the left tonight. lots of PB blaster, no heat.
my question regards the new bushings and reaming to fit the new pins. can i just bring the pins, bushings and spindles to someone experienced in reaming/honing? or do i need to bring in the whole darn axle too?
i've searched high and low here and i think letting someone else do it would be better, even though there are people here who have made home made reamers with good success.
andy
so i've gotten the right king pin out and am moving on to the left tonight. lots of PB blaster, no heat.
my question regards the new bushings and reaming to fit the new pins. can i just bring the pins, bushings and spindles to someone experienced in reaming/honing? or do i need to bring in the whole darn axle too?
i've searched high and low here and i think letting someone else do it would be better, even though there are people here who have made home made reamers with good success.
andy
