Boost cooler install question
Thread Starter
|
Freshman User
Joined: Jan 2007
Posts: 35
Likes: 0
Boost cooler install question
Anyone have a snow perf boost cooler installed on there PSD. I am putting one in on my 2003 PSD 6.0 and due to limited room under the hood will be using the windshield washer resevour for the coolant and the only place to mount the pump is on the fender wall just behind the passenger side battery. Question is, the instructions state to mount the pump level with or just below the coolant tank and this will be about 6 to 8 inches above the bottom of the tank. Anyone have a similiar set up and has it been working well or not.
Thanks
Thanks
Postmaster
Joined: Jun 2006
Posts: 2,799
Likes: 1
I had an aluminum tank in my bed with the pump mounted underneath. I think you can get a check valve to install in case you have to mount the pump higher than the tank. It was in the instructions if memory serves me correct.
